Fein ASW14-6 PC Instrucciones De Uso página 16

OBJ_BUCH-0000000157-002.book Page 16 Tuesday, February 17, 2015 1:44 PM
en
16
Working instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Do not use accessories not specifically intended and recommended for this power tool by FEIN.
The use of non-original FEIN accessories can lead to overheating of the power tool and destroy
it.
For each job, use only the FEIN application tool released and intended for the
CAUTION
respective application.
Switching on and off (figure 11).
Always hold the power tool
CAUTION
firmly. Otherwise, you could
lose control over the power tool.
The power tool is equipped with a soft-start-
ing feature.
If the motor switches off after a proper
screwdriving operation, restarting is not pos-
sible until after 0.8 seconds. This prevents
accidental retightening of already tightened
screws.
Switching on:
When pressing the On/Off switch halfway in,
the light goes on.
When pressing the On/Off switch completely
in, the light and the power tool are on.
Switching off:
To switch off the power tool, release the
On/Off switch.
Fig. 11
1.
2.
ASM 14-2 PC/ASM 14-6 PC/
ASM14-9 PC/ASM 14-12 PC/
ASM 14-2/ASM 14-6/ASM 14-9/ASM 14-12
ASW 14-6 PC/ASW 14-10 PC/ASW 14-14 PC/
ASW 14-6/ASW 14-10/ASW 14-14/ASW 14-30 PC