Control Modes - LEGRAND Wattstopper FSP-202 Manual Del Usuario

Ground
Non-Dimming
Driver
COM (Black)
Note: Dim Level functionality does not
apply when wired as shown above.
The FSP-202 has five selectable modes, each of which has preset parameter settings. Once
the mode is selected, you have the ability to further customize operation by adjusting the Dim
and the Time rotary trimpots.
Select the Mode and adjust the other rotary trimpots using a small screwdriver.
NOTE: A sixth mode, Test mode, is accessed automatically when mode C is selected. See
below for details.
Dim (High/Low) – This rotary trimpot adjusts either the low dim level (for modes A, B, C, and
E) or high dim level (for mode D).
When the Dim trimpot is turned, the load goes to the current dimming level, allowing visual
confirmation of the dim level. After the Dim trimpot has not moved for 3 minutes (this allows
time to reattach the lens to the sensor), the load will go to the maximum level for 10 seconds
and then turn OFF for 10 seconds. The load then returns to previous state before trimpot
adjustment. This process allows auto calibration of the photocell, for daylight control.
Time – This rotary trimpot sets the amount of time delay after occupancy is no longer detected
before the loads go to either the Low Trim value or turn OFF, depending on the mode.
Additionally, for Modes B and C, this controls the amount of time before the load goes from the
Low Trim to OFF. The time will be half of the initial delay. For example, if time is set to 20 minutes, the load will go from ON to the Low
Trim level 20 minutes after occupancy is no longer detected. The the load will then turn OFF 10 minutes after it goes to the Low Trim
level.
Neutral
Line
BZ-200 Power Pack
120 – 277 VAC (1 φ ), 50/60 Hz
20A Ballast/ELV/MLV/Tungsten/LED
LISTED
16A E-Ballast/CFL
Appliance
Control
1HP @ 120/240VAC
88T9
20A 120VAC Plug Load – Receptacle
Class 2 Output White Power Pack Red Lighting
Neut.
Load
24 VDC, 225 mA Switch
Black Red
Hot
Green
UL 2043 Plenum Rated
Ground
Control
Common Any 3-Wire
24VDC
+24VDC Sensor
www.wattstopper.com • 800.879.8585
16094r1
Class 2
wiring only
+VDC (Red)
CTRL (Blue)
COM/GND (Black)
0-10V – (Gray)
0-10V + (Violet)
Wiring with an external DC power supply

CONTROL MODES

WIRING
Dimming
0-10V – (Gray)
0-10V + (Violet)
Ground Neutral
Dim-to-Off
Driver
+VDC Output (Red)
3
Ground
Driver
Class 2
wiring only
COM (Black)
Line
Neutral
Line
BZ-200 Power Pack
120 – 277 VAC (1 φ ), 50/60 Hz
20A Ballast/ELV/MLV/Tungsten/LED
LISTED
16A E-Ballast/CFL Appliance
Control
1HP @ 120/240VAC 88T9
20A 120VAC Plug Load – Receptacle
Class 2 Output White Power Pack Red Lighting
Neut.
Load
24 VDC, 225 mA Switch
Red
Black
Hot Green
UL 2043 Plenum Rated
Ground
Control
Common Any 3-Wire
24VDC
+24VDC Sensor
www.wattstopper.com • 800.879.8585
16094r1
+VDC (Red)
CTRL (Blue)