LEGRAND Wattstopper FSP-202 Manual Del Usuario página 5

Daylight Control
Mode A* Yes
Mode B Yes
Mode C
No
Mode D Yes
Mode E No
* Default Mode Setting
Lights do not turn ON at Full Value:
• Make sure that the sensor is not obstructed.
• If Mode is set to A or B, check light level parameter, to find out the amount of light that the sensor is detecting. Cover the sensor
lens to simulate darkness in the room. If the lights come ON, the ambient light level is too high.
• If the red LED blinks 1 time per second, the FSP-202 is in short circuit protection mode.
• If the red LED blinks 2 times per second when the sensor is triggered, and in modes A, B, or D, the ambient light level is too high.
• Make sure the FSP-202 is not set to Mode E (Service mode) and time delay rotary trimpot is not at minimum position.
• If lights still do not turn ON, call 800.879.8585 for technical support.
Lights will not go to Dimming Level:
• Check all wire connections and verify the dimming wires are tightly secured.
• Make sure that the sensor is not obstructed.
• If Mode is set to D, check light level parameter, to find out the amount of light that the sensor is detecting. Cover the sensor lens to
simulate darkness in the room. If the lights adjust to the dimming level, the ambient light level is too high.
• The time delay can be set from a minimum of 30 seconds to a maximum of 30 minutes. Ensure that the time delay is set to the
desired delay and that there is no movement within the sensor's view for that time period.
• To quickly test the unit operation, enable test mode and move out of the sensor's view. Lights should fade to the dim level after 5
seconds and then turn OFF after 2.5 seconds.
• If lights still do not adjust to the dimming level, call 800.879.8585 for technical support.
Lights will not turn OFF:
• Make sure the FSP-202 is not set to Mode E (Service mode) and time delay rotary trimpot is not at max position.
• To quickly test the unit operation, enable test mode and move out of the sensor's view. Lights should fade to the dim level after 5
seconds and then turn OFF after 2.5 seconds.
• False Triggering may occur if the sensor is exposed to high ambient temperature conditions, so ensure the installed location has
good ambient temperature.
• If lights still do not turn OFF, call 800.879.8585 for technical support.
High/Low Dim
Low Dim
Default Level–Min. (1V)
Low Dim
Low Dim
High Dim
Low Dim
TROUBLESHOOTING
Time Delay
30sec–30 min Ambient light level below
daylight control level
Default–15 min.
30sec–30 min Ambient light level below
daylight control level and
1/2 of set value
occupancy detected
during Low Trim
30sec–30 min Occupancy detected
1/2 of set value
during Low Trim
30sec–30 min Ambient light level below
daylight control level and
occupancy detected
Not applicable Load is ON at Dim level
when time delay rotary
trimpot in maximum
position
5
Auto On
Ambient light level above
daylight control level
One half time delay expired
or ambient light level above
daylight control level
One half time delay expired
Time delay expired or
ambient light level above
daylight control level
Load is OFF when time
delay rotary trimpot in
minimum position
Auto Off