Philips Avent SCD530 Manual Del Usuario página 10

EngliSh
10
6 K = lullaby symbol
7 Q = nightlight symbol
8 T = battery symbol
9 Volume/microphone sensitivity indications:
- = volume off
g
- = minimum sensitivity/volume
h
- = maximum sensitivity/volume
i
Other display indications (not shown):
- 'High' = room temperature above temperature set in menu
- 'Low' = room temperature below temperature set in menu
- 'Not linked' = no connection between units*
- 'Paused' = lullaby is interrupted
- 'Searching' = units are searching for connection*
- 'Linked' = units are linked*
- 'Talk' = talk function is active
* This is only shown on the display of the parent unit.
D Travel pouch
important
Read the user manual carefully before you use the appliance and save it for future reference.
,
This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
,
supervision and should not be used as such.
This monitor is not intended to be used as a medical monitor and its use should not replace
,
adult supervision.
Check if the voltage indicated on the adapter corresponds to the local electrical voltage
,
before you connect the appliance.
This appliance is suitable for electrical outlet voltages of 10V.
,
Use and store the appliance at a temperature between 50°F (10°C) and 10°F (0°C).
,
Do not expose the baby monitor to extreme cold or heat or to direct sunlight.
,
Make sure the baby unit and power cord are always out of reach of the baby (at least  feet/1
,
meter away).
Never place the baby unit inside the baby's bed or playpen.
,
Never cover the baby monitor with a towel or blanket.
,
Never immerse any part of the baby monitor in water or any other liquid.
,
Never use the baby monitor in moist places or close to water.
,
Except for the battery compartment, do not open the housing of the baby unit and parent
,
unit in order to prevent electric shock.
Only use the adapters supplied.
,
The adapters contain a transformer. Do not cut off the adapters to replace them with other
,
plugs, as this will cause a hazardous situation.
If one of the adapters is damaged, always have it replace with one of the original type in
,
order to avoid a hazard.
If you place the parent unit next to a transmitter or other DECT appliance (e.g. a DECT
,
telephone), the connection with the baby unit may be lost.
The temperature and humidity sensor only measures the temperature and humidity in the
,
baby's room. It cannot be used to control or adjust the temperature and humidity in the
baby's room.
The power outlet should be located near the appliance and easily accessible.
,