Cleaning And Maintenance - Bestron DDF35W Manual Del Usuario

user's instructions
the nut and bolt (2G). Use a
crosshead screwdriver.
7. Close the other clamps.
operATIon - Ventilate
1. Set the fan on a level surface, such as a table.
2. T ilt the fan to the required angle (see figure 3). You can set the
fan:
a. t o blow horizontally (position a) or angled slightly downwards
(position b). Tilt the ventilator housing and motor housing to
the required angle.
b. t o oscillate from left to right (with a sweep of 90 °). This will
ventilate much of the room. Press the oscillation button on the
motor housing fully in.
c. r emain in the same position whilst the fan is turning. This will
ventilate one area. Pull out the oscillation button until you
hear it click.
3. Put the plug into the wall socket.
4. S witch on the fan by pressing one of the three speed buttons.
a. Position '1', the fan operates at low speed.
b. P osition '2', the fan operates at normal speed.
c. Position '3', the fan operates at high speed.
5. S top the fan by pressing the stop button (position '0').

cleAnInG AnD MAInTenAnce

Over the course of time dust can accumulate between the spokes in the fan housing, and on the fan blades.
Always begin by trying to remove the dust with a brush and/or vacuum cleaner. If this does not remove all
the dust you can always dismantle the fan and clean it.
1. R emove the plug from the wall socket.
2. L oosen the bolt in the rim around the fan housing using a small crosshead screwdriver.
3. R emove the rim and the front half of the filter housing.
4. H old the fan blades to stop them from turning, and unscrew the white spinner by turning clockwise in the
direction of the 'LOOSEN' arrow. Remove the fan blades from the motor housing.
5. R emove the rear half of the fan housing by turning the white locking ring at the centre of the housing
anticlockwise. Remove the ring and the housing from the motor housing.
6. C lean the dismantled parts and the base with a damp cloth. Dry thoroughly with a dry cloth.
7. C lean the motor housing with a dry cloth.
• V erify that the appliance is not connected to the power supply before you clean it.
• N ever use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
Reassemble the fan using the procedure given under by 'Assembling the fan'.
F
D
E
G
17
B
C
A
a
b