HP OneLam Combo A3 Manual De Instrucciones página 24

EN
3
Raise the guide rail up as far as possible (H) and slide the guide rail to the right (I) until the
guide rail is released from the left-hand holder. Remove the guide rail.
Î You have disassembled the guide rail together with the cutting head.
Caution!
Risk of injury through sharp cutting device!
Do not touch the knife blades in the cutting heads to be changed.
4
Pull the old cutting head from the guide rail.
5
Assemble the new cutting head on the guide rail in the direction of installation.
6
With the lock released (=> Step 2), fit the guide rail with the cutting head firstly in the right-
hand holder and then in the left-hand holder.
7
Remove the tool from the recess and engage the lock.
8
Check that the guide rail and cutting head are fitted properly.
9
Fix the plastic rail in place.
10
Check the function of the cutting head.
Î The cutting head has been changed.
Using the Corner Rounder
The corner rounder is on the underside of the laminator.
Caution!
Risk of injury through sharp cutting device!
Do not touch the knife blades in the corner rounder.
1
Release the corner rounder (E) from the holder.
2
Fit a corner of the paper/pouch in the corner rounder.
3
Press the corner rounder together.
4
If necessary, repeat the process on all the corners of the paper/pouch.
Î The corners of the paper/pouch have been rounded.
E
- 24 -