Nozzles; Nozzle Maintenance - Wilks USA RX525i Operación Manual

RX525i
The supplied nozzles attach to the lance that screws
into the gun. These provide a variety of pressures and
patterns designed for different cleaning applications.

Nozzles

The nozzles are stored in a panel mounted to the handle
of the washer
Fig.1F
Red 0°Nozzle: This nozzle delivers a pinpoint stream of
pressurized water and is extremely powerful. It should
only be directed at surfaces that can withstand high
pressure such as metal or concrete. (Fig 1)
Green 25° Nozzle: This nozzle delivers a 25 degree
spray pattern for intense cleaning of larger areas. This
nozzle should only be used on areas that can withstand
very high pressure. (Fig 2)
Black / Blue Detergent Nozzle: This nozzle is used
to apply detergent and cleaning solutions. This nozzle
produces the weakest pressure of the three nozzles.
(Fig 3)
To avoid damaging your cleaning surface, always start
with the lowest pressure nozzle and work up through to
the higher pressure nozzles.
ig.2 Fig.3
English

Nozzle Maintenance

A clogged or partially clogged nozzle can significantly
reduce water flow and cause the unit to pulsate while
spraying. To clean the nozzle:
1. Turn off and unplug the unit from the electric mains.
2. Turn off the water supply and relieve any pressure
trapped in the hose by squeezing gun trigger 2-3
times.
3. Separate lance from gun.
4. Rotate the nozzle to the narrow high impact stream
setting. This opens up the fan blades.
5. Using the included tip cleaner, or an unfolded paper
clip, insert the wire into the nozzle hole and move back
and forth until any debris is dislodged.
6. Remove additional debris by back-flushing water
through the nozzle. To do this, place end of a garden hose
(with water running) to end of nozzle for 30-60 seconds.
Insert tip cleaner into the nozzle hole and move back and
forth until debris is dislodged
© Wilks-USA
5