Water Heater Drain In Case Of Frost - Aparici SIE030N Manual Del Usuario Y Del Instalador

Ver 2_ES_EN_FR_IT_PT
Position 'ECO': 55ºC approximately. Optimal temperature to reduce heat loses to environment and
reduce scales inside the appliance in hard water areas.
Position '+': 75ºC. Maximum water temperature inside the tank.
The operation of electric immersion heater is shown by pilot light.
Double power switch:
Just over the pilot light it is placed the double power switch. If it is placed at position '
heating element is working and a led light with this symbol is illuminated. In this case the instantaneous electricity
consumption is lower but the heating time is higher. By contrary, if switch is placed at '
instantaneous electricity consumption is higher but the heating time is lower. When this position is selected a pilot
light over the switch with this symbol is lighted.
2.- CLEANING.
The external parts of the water heater may be cleaned with a mild detergent solution. Do not use solvents and
abrasives.
Never try to repair any possible faults of the water heater by yourself, but inform about it the

3.- WATER HEATER DRAIN IN CASE OF FROST

At any risk for freezing of water in the water heater, the water must be emptied from it. In order to do it,
please follow the below instructions:
Unplug the appliance from electrical network.
o
Close the water inlet to the water heater.
o
Drain the water heater using the safety valve..
o
Protect the safety valve from freezing.
o
Fill the water heater before plug in it again to electrical network.
o
nearest authorised service workshop.
14
' only one
' position, the