Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
After having addressed all devices, you may now start operating these via your lighting controller.
Note: In order to change from DMX-controlled operation back to Stand Alone operation, please disconnect
DMX-protocol
Channel 1
Red
0 - 255
0-100 %
Channel 2
Green
0 - 255
0-100 %
Channel 3
Blue
0 - 255
0-100 %
Channel 4
Dimmer
0 – 255
0-100 %
Channel 5
Flash
0 - 10
No function
11 - 255
0-100 % with increasing speed
Inserting/Replacing the battery
Open the battery cover on the rear of the remote control and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Leaky or damaged batteries might cause cauterisation when in contact with the skin; therefore, use suitable
protective gloves.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
If the device will not be used for a longer period of time, remove the battery in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
CLEANING AND MAINTENANCE
the device from the DMX-controller.
Danger of explosion when battery is replaced improperly.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Caution!
18/35
00042630.DOC, Version 1.0
Publicidad
Tabla de contenido
