Overview Of The Controller Buttons; Cleaning And Maintenance; Replacing The Fuse - EuroLite LED CB-8 Manual Del Usuario

Connect the system to the mains with the power-plug.
With the POWER-switch, you can switch the device on and off.
Via the NUMBER button on the controller, please set the number of connected luminaries.
You can select the programs by pressing the buttons on the controller as well as on the IR remote control.
Attention: The controller can be used with up to 8 luminaries.

Overview of the controller buttons:

POWER: On and off switch
COLOR: Color selection
PROGRAM: Program selection
SENSOR +: Increasing sensitivity
MUSIC SENSOR: Sound control
SENSOR -: Decreasing sensitivity
PAUSE: Pause
SPEED: Speed
NUMBER: Number of connected luminaries

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
14/27 51930475_V_1_1.DOC