Tuning Into A Preset Station - JVC KS-FX210 Manual De Instrucciones

Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the button, the FM
band changes as follows:
F M
FM1
2
Tune into a station of 88.3 MHz.
ST
3
Press and hold the number button
(in this example, 1) for more than
2 seconds.
ST
Preset number "P1" flashes for a while
8
FM2 FM3
To tune into stations
of higher frequencies.
To tune into stations
of lower frequencies.
BEAT POP SOFT
LOUD
BEAT POP SOFT LOUD
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 7.
1
Select the band (FM1 – 3, AM).
FM1
F M
A M
AM
2
Select the number (1 – 6) for the
preset station you want.
FM2
FM3