Getting To Know Your Appliance; Accessories; Gas Burners; Switching On Manually - Bosch POP6B6B80V Instrucciones De Uso

Getting to know your appliance

en
*Getting to know your
appliance
Y ou can find your appliance and the burner powers in
G e t t i n g t o k n o w y o u r a p p l i a n c e
the model overview. ~ Page 2

Accessories

The following accessories can be purchased from the
Technical Assistance Service:
--------
Code
HEZ298114 Additional espresso maker grid
HEZ298105 Simmer Plate
HEZ298104 Simmer cap
The manufacturer accepts no liability if these
accessories are not used or are used incorrectly.
6
Additional espresso maker
grid
Only suitable for use on the
smallest burner. Use cookware
with a diameter of less than
12 cm.
Simmer plate
This accessory part is only suita-
ble for simmering. It can be
used with the economy burner
or the standard-output burner. If
your hob has several standard-
output burners, we recommend
placing the simmer plate on the
rear or front-right standard-out-
put burner.
Place the accessory component
with the projections facing
upwards on the holder; never
place it directly on the burner.
Simmer cap
Burner that is used only when
cooking at minimum output. To
use it, the economy burner must
be removed and replaced with
the simmer cap.
ÄGas burners
T here are indications to show which burner each
G a s b u r n e r s
control knob operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to
work correctly. Do not swap the burner caps around.

Switching on manually

Press the chosen burner control knob and turn it
1.
anticlockwise to the required setting.
Use any type of lighter or flame (cigarette lighter,
2.
matches, etc.) and bring it close to the burner.

Switching on automatically

If your hob can be switched on automatically (ignition
sparkers):
Press the chosen burner control knob and turn it
1.
anticlockwise to the maximum power setting.
While the control knob is still pressed down, sparks
are produced on all burners. The flame ignites.
Release the control knob.
2.
Turn the control knob to the required setting.
3.
If it does not come on, turn the control knob to the off
setting and repeat the steps above. This time, press
and hold the control knob for longer (up to 10
seconds).
:
Warning – Risk of deflagration!
If after 15 seconds the flame does not ignite, switch off
the burner and open a nearby window or door. Wait at
least one minute before trying to switch the burner back
on.