Adjust Calf Support; Care And Maintenance - Joie mirus Manual De Instrucciones

Adjust Calf Support

There are three reclining angles, 1-3 20 , for adjustment.
To raise calf support, push the calf support from position 1 to position 3.
To lower calf support, press the adjustment buttons on both sides of the calf support
- 2
support downwards.
21
Use Hood
To open the hood, pull hood toward front. 22
To fold the hood, push hood toward back.
Use Hood Window
There is one window on the hood.
To open the window, pull back hood flap.
Switch Handle Direction
To change handle position, pull up the left and right reversible sliders
- 2
side until it clicks into place.
23
!
Make sure child's hands and legs are clear from the armrest when switching the handle.
Use Front Swivel Lock
Pull up the front swivel locks to maintain the moving direction.
Tip
It is recommended to use swivel lock on uneven surfaces.
Use Brake
To lock front wheels, step on the brake levers.
25
To lock rear wheels, step on the brake lever. Lift the brake lever to release wheels.
26
Tip The brake must be engaged when placing and removing children.
Tip Always apply brake when stroller is in stopped position.
Tip To ensure brake is fully on, gently rock the stroller backwards and forwards before releasing the handle.
!
WARNING To prevent potential hazard, always make sure the parking device for all swiveling wheels are
engaged and the swiveling wheels are locked when you use the handle in reversed position.
Use Accessories
- 1
27 Seat Pad
- 3
27 Shoulder Harness Cover
- 5
Armbar Cover
27
Accessories may be sold separately or may not be available depending on region.
Use Seat Pad
The snap on the back of the stroller should be detached when removing the seat pad.
28
Tip Use seat pad in cold weather to provide a comfortable seating area.
13
20
- 1
21 , and rotate the calf
- 1
23 and move the handle to the other
24
Lift the brake levers to release wheels.
- 2
27 Head Support
- 4
27 Crotch Harness Cover
- 6
Rain Cover
27
29
Use Rain Cover
To assemble the rain cover, place it over the stroller, and then attach the hook and loop fasteners on the rain
cover. 30
!
Before using the rain cover, please make sure the backrest has been adjusted to the lowest position and the
infant child restraint has been fastened.
! When using the rain cover, please always check its ventilation.
!
When not in use, please check that the rain cover has been cleaned and dried before folding.
!
If the rain cover is on the stroller, always remove rain cover to prevent ripping and tearing.
!
Do not place your child into the stroller assembled with rain cover during hot weather.

Care and Maintenance

1. Removable seat pad may be washed in cold water and drip-dried. No bleach.
2. To clean stroller frame, use only household soap and warm water. No bleach or detergent.
3. From time to time check your stroller for loose screws, worn parts, torn material or stitching. Replace
or repair the parts as needed.
4. Excessive exposure to sun or heat could cause fading or warping of parts.
5. If stroller becomes wet, open hood and allow to dry thoroughly before storing.
6. If wheels squeak, use a light oil (e.g., Silicon Spray, antirust oil, or sewing machine oil). It is important
to get the oil into the axle and wheel assembly.
7. When using your stroller at the beach, completely clean your stroller afterward to remove sand and
salt from mechanisms and wheel assemblies.
1
14