D-Link DAP-2610 Guia De Instalacion página 4

Power on the access point
To power on the DAP-2610, you can use ONE of the following methods:
1. Plug one end of your Ethernet cable into the LAN port of the DAP-2610, and the
other end into a port on a PoE switch.
2. Purchase separately a DPE-101GI PoE injector if you need to connect the Access
Point without a PoE Switch.
Configure the access point
PoE Switch
Computer
To set up and manage the DAP-2610, use one of the following methods:
1. Connect the access point and your computer via DPE-101GI. Manage the access
point from the computer.
Ensure your computer is configured with a static IP address in 192.168.0.0/24 subnet.
Launch a web browser, type the default IP address of the access point
(http://192.168.0.50) and then press Enter.
Log in to the Administration Web pages. The default login information is:
Username: admin
Password: (Leave the password field blank)
2. Connect the access point and your computer to the same switch. Manage the
access point from the computer.
Enter 192.168.0.50 in the address field of your browser, which is the default IP
address of the access point.
Log in to the Administration Web pages. The default login information is:
Username: admin
Password: (Leave the password field blank)
4
3. Installation
DAP-2610
OR
PoE Injector
D-Link DAP-2610 Quick Install Guide
Power
Adapter
Computer