Cleaning And Storage; Technical Data - JOCCA 5454 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

16-EN
pushing gently upwards.
2.-Separate the jug filter.
3.-To remove the jug, turn this anti-clockwise and slide it upwards
to separate it from the motor base.
4.-Separate the spindle from the motor base by pulling upwards
strongly.
5.-To put the liquidiser back together again, please do the same
in reverse.
OPERATION
-Unroll the cable from the base and plug it into the electricity
mains supply.
-Cut the fruit to be liquidised in half and place it over the cone.
-Lightly press the fruit against the cone and the liquidiser will
automatically start up. The lid can be used to help pressing the
fruit down. The squeezed juice will immediately run down into
the jar which has a level indicator to know the amount of juice
that has been pressed at all times. The liquidiser will turn either
to the right or to the left to better liquidise and obtain the juice.
-When you stop pressing down the liquidiser will stop. Frequent
cleaning of the filter is recommended when liquidising to obtain
a large amount of juice.
-Please do not operate the liquidiser continuously for more than
10 minutes at a time.
-Please unplug the appliance from the electricity supply when
not in use.

CLEANING AND STORAGE

-Before cleaning the appliance, make sure it has been
disconnected from the mains.
-Do not use abrasive detergents or products that may damage
the appliance.
-NEVER IMMERSE THE APPLIANCE IN WATER OR ANY OTHER
LIQUID.
-Use a damp cloth or sponge to clean the motor base.
-Separate the parts of the juicer. (Refer to section "BEFORE FIRST
USE")
-Wash the cover, reaming cone, filter and the axle with soapy
water and dry with a cloth.
-After each use clean all parts of the juicer immediately because
once the pulp is dry it is more difficult to clean.
-Store the appliance in a safe place.

TECHNICAL DATA

220-240V ~ 50Hz 25 W
This device conforms to the safety requirements and provisions of
directives 2006/95/CE on Low tension devices and 2004/108/CE on
Electromagnetic Compatibility.
PROTECTION OF THE ENVIROMENT - DIRECTIVE
2002/96/CE
This product has been designed and manufactured with high
quality materials and components that can be recycled and
reused.
When you see the symbol of a crossed out litter bin on wheels
next to a product, this means that the product conforms to
the European Directive 2002/96/CE.
Please obtain information about the local recycling system
for electric and electronic products.
Follow the local rules and do not dispose of used products
by throwing them in the normal bins at home. Proper
recycling of your used product will help avoid negative impacts
on the environment and people's health.
EN-17

Publicidad

Tabla de contenido
loading

Tabla de contenido