Cleaning And Maintenance; Basic Cleaning - essentiel b ECHS 2001VH Instrucciones De Uso

Switching the screen on/off
By default, the screen switches off approximately one minute after your settings (except for
the symbol whichremains on if the appliance is in the heating phase). This avoids, for
example, light projections in a room at night. If you want the screen to stay on constantly,
proceed as follows:
1. Simultaneously press the and
3 seconds until a beep sounds. The screen lights up continuously.
2. To switch the display off again after you have made your settings, simultaneously press the
and buttons on the control panel for 3 seconds until a beep sounds.
When you have finished
1. When you have finished, press the
continues for 15 seconds to allow the appliance to cool down. The ventilation countdown
appears on screen, after which the appliance automatically stops at the end of the
countdown.
Note: if you leave the appliance in standby mode, it will operate in accordance with the last
settings made when it is restarted.
2. When the appliance is turned off, set the switch on the back of the appliance to 0 (power
off) and unplug the appliance.
Thermal safety: if the appliance overheats (e.g. if a cloth covers the appliance),
•
it automatically stops working. Uncover it before restarting it.
20
V.2.0
use
buttons on the control panel, and hold them down for
button to switch the appliance off. Ventilation

cleaning and maintenance

IMPORTANT:
Always unplug the power cord from the power
•
socket and allow the appliance to cool down before
cleaning or maintaining it.
Never immerse the appliance in water or any other
•
liquid.
Never use abrasive cleaning products on this
•
appliance (alcohol, solvent).

Basic cleaning

1. Use a slightly damp cloth to wipe the outside of the heater to remove dust and dirt.
2. Use a vacuum cleaner to remove dust from ventilation holes.
3. Make sure the heater is dry before plugging it back in.
Thorough cleaning
1. Gently pull the release latches at the bottom of the air intake grille on the back of the
appliance, then remove the grille.
2. Pull out the black filter behind the grille.
3. Soak the filter in clean, clear water for a few minutes, then dry it thoroughly.
4. Clean the filter compartment with a soft, dry cloth.
5. Put the dry filter back behind the grille.
6. Put the air intake grille back on the appliance until it clicks into place.
If the appliance is not going to be used for an extended period
If you do not plan to use the appliance for an extended period:
1. Turn off and unplug the appliance.
2. Clean the appliance as described in the section above.
3. Remove the batteries from the remote control and store them with the appliance in a clean,
dry place.
21
V.2.0
cleaning and maintenance