JSG Oceana Rectangle Undermount Serie Guía De Instalación Y Cuidado página 3

Undermount Installation Instructions:
Tools and Materials:
1. Inspect sink prior to installation. No returns accepted after installation
unless product is mechanically defected.
2. Provide your countertop manufacturer with your lavatory template
(provided), to assist in your granite cut-out. Templates are supplied
only as a guideline, the physical use of the sink will assure an accurate
cut-out. JSG Oceana takes no responsibility for inaccurate cutting of
the granite.
3. Pre-install the drain to the lavatory, if possible.
4. Clean the underside of the countertop and the rim of the lavatory.
5. Loosely install the clips (not provided) into your pre-drilled counter-
top.
6. Apply a clear epoxy/caulking to the top rim of the undermount and
then hold it in place under the countertop.
7. While holding the lavatory in place, rotate & tighten clips evenly.
8. Wipe away excess sealant and allow sealant time to set, according to
sealant manufacturer's instructions.
9. Complete the water supply and drain connections.
10. Run water into the lavatory and check for leaks.
½"
6"
21 ⅝"
1 ¾" drain hole
Sealant
Sink
Allow 2" minimum for clearance
around sink rim for clip attachment.
Sealant
Countertop
Foam bumpers (optional)
Clip (not included)
L Bracket