Led Display - Hoover Jazz SM96WD4 011 Manual De Instrucciones

FEATURES
A On/Off switch**
B

LED Display*

C LED Charging Indicator**
D Removable Crevice Tool
E suction Inlet
F Power Nozzle*
G Dust Bin Flap
STORAGE/CHARGING
UNIT STORAGE
The product is designed to sit in the charging base on a flat surface or vertically if wall mounted. [1]
For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom.
To Wall Mount (Tools required: Screwdriver and drill)
1. Place the cardboard ruler against the mounting surface. Mark the centres of the holes.
2. Move base then drill 4.8mm holes.
3. Fit wall plugs.
4. Position base into the insert screws, and move down to ensure the base is fixed firmly to the wall.
CHARGING & LED INDICATOR**
Ensure the product on/off switch** button is at the "OFF" position, then place the cleaner into the base, ensuring the shroud covers
the back of the product.
For the cleaner with LED Display *. The charging LED indicator** will flash to advise that the product is charging. When the product
is fully charged and is still positioned on the charger base, the icon will stop flashing and remain lit.
For the cleaner without LED Display *. The charging LED indicator** will illuminate red all the time to advise that the product is
charging. When the product is fully charged and is still positioned on the charger base, the red led will remain on.
NOTE: Use only the charger supplied with your cleaner to recharge the unit.
IMPORTANT: Before first use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be
off. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use,
let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in
temperatures above 37°C or below 0°C.
HOW TO USE
1. Remove the cleaner from the storage base.
2. Push the switch** to 'ON' position to begin cleaning and to turn off move the switch** to the 'OFF' position.
3. For the cleaner with Power Nozzle*, push the switch** to "1" position to begin cleaning and to turn off move the switch** to the
"0" position, push the switch** to "Power Nozzle Icon
4. Empty and clean the unit and filter after each use.
5. To empty the bin pull the bin open trigger, the dust bin flap will open and stop about 45 °position for debris to empty easily. [2]
IMPORTANT: For best results clean the filter after each use.
LED DISPLAY*
This cleaner is equipped with a LED display. When the product is on, the display will report following information:
Battery Level Indicator*:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
• 1 bar = 25% charge
• 0 bar <= 5% charge
*certain models only ** May vary according to model
H Charger Base
I Cardboard Ruler
J Charger
K Dust Brush
L Dust Bin Open Trigger
M Flexible Hose*
N Crevice Brush*
" to turn on the power nozzle.
3
GB