HQ-Power VDPDP134 Manual Del Usuario página 4

4. Features
This powerful and versatile device features 6 channels with LED indication. The device is controlled
through DMX or an analogue input and is equipped with a preheating function and a two-phase power
output.

6 channels controlled by DMX-512 or 0-10 V

LED indicator and dimmer-fader for each channel

adjustable preheating function from 0 to 50 %
5. Overview
Refer to the illustrations on page 2 of this manual.
1
automatic circuit breakers 20 A
2 preheating adjustments max. 50 %
3 power on indicator
4 DMX channel output indicators
5 DMX ON indicator
6 power switch
7 DMX channel output faders
8 start address DIP switches
6. Connection
Remove the cover of the load connection box and connect the mains and the load to the device according
to the figure above.
7. Operation
Refer to the illustrations on page 2 of this manual.
Manual control
Preheating
Analogue input
DMX input
Setting the DMX Start Address
V. 02 – 22/09/2014
Manual control is possible through the channel faders if neither an analogue or
DMX controller are used. Slide them up or down to adjust the output (dimming
level) for each channel.
Enables you to adjust the min. output level (between 0-50 %), which enhances
the life of the lamps.
Connect the analogue controller according to the diagram below. The device
supplies the controller with DC power.
The dimmer pack can receive DMX-512 signals. Adjust the DIP switches to
confirm the start address of the device. When the 10
position and you move one of the sliders, then all channels will react
simultaneously and they will all be placed at the same level.
VDPDP134
9
load indicators
10 analogue input (0-10 VDC)
11 analogue output
12 DMX input (3-pin male XLR)
13 DMX output (3-pin female XLR)
14 Schuko sockets
15 power input
4
th
switch is placed in the ON-
©Velleman nv