Omega 72101 Instrucciones De Operación Y Manual De Piezas página 4

Failure to comply with the following warnings
may result in personal injury as well as
property damage.
• Study, understand, and follow all instructions
provided with and on this device before use.
• The user must be a qualified operator familiar with
the correct operation, maintenance, and use of
cylinders.
This device is NOT suitable for use as
support device! As the load is lifted, use
blocking and cribbing to guard against a
falling load. Stay clear of a lifted load before it
is properly supported. Never rely on hydraulic pressure
to support a load.
Crush Hazard. Keep hands and feet
away from cylinder and workpiece
during operation.
• Do not exceed rated capacity of the cylinder
or any equipment in the system. The cylinder
is designed for a max. pressure of 10,000 psi.
• Do not connect a cylinder to a pump with higher
pressure rating.
• Do not subject cylinder to a shock loads, a load
dropped suddenly, causing the system pressure to
exceed rated pressure.
The system operating pressure must
not exceed the pressure rating of the lowest
rated component in the system. Install a
pressure gauge or other load measuring instrument to
monitor the operating pressure. Burst hazard exists if
hose, connection or any other component in the system
exceed its rated pressure.
Avoid damaging hydraulic hose. Do not allow
hose to kink, twist, curl, crush, cut or bend so
tightly that fluid flow within the hose is blocked
or reduced. Periodically inspect the hose for
wear.
Do not pull, position or move cylinder setup by
the hose. Use carrying handle or other means
of safe transport.
!
Wear protective gear when
operating hydraulic equipment.
WARNING
disconnecting hydraulic hose or connections.
in fluid leaks. Heat also weakens hose materials.
prevent slippage of the base or load. Ensure cylinder is
fully engaged into/onto adapters, extension accessories.
service center.
and wet paint. Never paint a coupler or hose.
• No alteration shall be made to the cylinder.
• Use only factory authorized fasteners,
4
Do not handle pressurized hoses. Never
attempt to grasp a leaking pressurized hose.
Ensure to release the system pressure before
Hydraulic fluid can ignite and burn. Keep
hydraulic equipment away from flames and
heat. Excessive heat will soften seals, resulting
Cylinder must be on a stable base which is
able to support the load while pushing or lifting.
Use shims, friction material or constrains to
Center load on cylinder. Distribute load evenly
across the entire saddle surface. Do not
off-center loads on a cylinder. The load can tip
or the cylinder can "kick out".
Never try to disassemble a hydraulic cylinder,
refer repairs to qualified, authorized personal.
Contact Omega tech service for authorized
Do not subject hose to sharp objects or
heavy impact.
Hose material or seals must not come in
contact with corrosive materials such as
battery acid, creosote-impregnated objects
accessories and hydraulic fluid.