Cleaning And Maintenance - Elite PS250 Manual De Usuario

CLEANING & MAINTENANCE
GENERAL INSPECTION
Regularly check that all the screws are tight as they may vibrate and loosen over time.
Inspect the POWER CABLE (3) prior to each use for damage or wear.
Repairs should only be carried out by a qualified technician.
Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly and shorten the
tool's service life. Clean the body of the tool with a soft brush or dry cloth.
We recommend using compressed air when possible to clean down the Sander. This aids the products
longevity.
CAUTION: Never use caustic agents to clean plastic parts. If dry cleaning is not sufficient, using a mild
detergent on a damp cloth is recommended.
WARNING! Do not allow the tool to come into contact with water or any other liquid. Ensure the tool is
thoroughly dry before using it. If available, use clean, dry, compressed air to blow through the ventilation
holes (where applicable). Surfaces need to be clean, free of dirt and foreign matter (hair, sand etc.) and
in good condition.
10
www.ELITETOOLS.co
Keep Working