Getting Started; Accessory List; Turning Power On And Off; Detaching And Attaching The Front Panel - Alpine CDE-9873 Manual De Operación

Getting Started

Rotary encoder
/ /ENT SOURCE/
(MUTE)/ (Release)
A.SEL/SETUP
RTN

Accessory List

• Head unit ............................................................................1
• Power cable........................................................................1
• Mounting sleeve.................................................................1
• Carrying case .....................................................................1
• Bracket key.........................................................................2
• Screw (M5 × 8)....................................................................4
• Owner's Manual .......................................................... 1 set

Turning Power On and Off

Press SOURCE/ to turn on the unit.
• The unit can be turned on by pressing any other button except TITLE,
and (Release).
Press and hold SOURCE/
turn off the unit.
• The first time power is turned on, the volume will start from level 12.

Detaching and Attaching the Front Panel

Detaching
1
Turn off the unit power.
2
Press (Release) at the lower left side until the
front panel pops out.
3
Grasp the left side of the front panel and pull it out.
• The front panel may become hot in normal usage (especially the
connector terminals on the back of the front panel). This is not a
malfunction.
• To protect the front panel, place it in the supplied carrying case.
• When detaching the front panel, do not apply excessive force as it
may result in malfunction.
6
-EN
for at least 2 seconds to
Attaching
1
Insert the right side of the front panel into the main
unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
• Before attaching the front panel, make sure that there is no dirt or
dust on the connector terminals and no foreign object between the
front panel and the main unit.
• Attach the front panel carefully, holding the sides of the front panel to
avoid pushing buttons by mistake.

Initial System Start-Up

Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Remove the detachable front panel.
3
Press RESET with a ballpoint pen or similar pointed
object.
RESET switch

Adjusting Volume

Turn the Rotary encoder until the desired sound is
obtained.
1