Basic Operation - Tripp-Lite SmartPro 2U Manual Del Propietário

Basic Operation

LCD Interface
3-Digit Display: This display is generally used to show values for a given
"Display" or "Control" screen.
"ON/OFF" Button
• To turn the UPS ON: After you plug the UPS into a live AC outlet, the UPS (in
• To cold-start the UPS: If utility power is absent, you can "cold-start" the UPS
• To turn the UPS OFF: With the UPS ON and receiving utility power, press and
* If the user unintentionally presses the ON/OFF button, the OFF function can be temporarily
"MODE" Button
To enable viewing of power displays and control menu options, tap this button.
See "Display Power Conditions" & "Control Menu Options" for details.
• Can be used in conjunction with the ON/OFF button to cancel the "OFF"
• Can be used in conjunction with the ENTER/MUTE button to restore the LCD
14-03-028-93-3088.indb 9
"Standby" mode) will automatically charge its batteries, but will not supply
power to its outlets until it is turned ON. With the UPS plugged into a live AC
wall outlet, press and hold the "ON/OFF" button for one second.* The UPS
will beep once to indicate ON status. Release the button.
(i.e.: turn it ON and supply power for a limited time from its batteries) by
pressing and holding the "ON/OFF" button for one second.* The UPS will beep
once to indicate ON status. Release the button.
hold the "ON/OFF" button for 2.5 seconds.* The UPS will beep once to
indicate OFF status. Then unplug the UPS from the wall outlet. The UPS will
be completely OFF.
canceled by continuing to hold the ON/OFF button until the UPS beeps and then
momentarily pressing either the MODE button or the ENTER/MUTE button. Once both
buttons are released, the UPS will remain ON.
function. See "ON/OFF Button" instructions above.
to Factory Mode. See "Control Menu Options".
Note: This LCD image is shown
with all icons illuminated. Under
normal conditions, only select
icons will be lit.
9
3/20/2014 4:08:44 PM