Technical Specification - Beamz 151.284 Manual De Instrucciones

FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light
output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty
surrounding can cause greater accumulation of dirt on the unit's optics.

Make sure the area below the installation place is free from unwanted persons during servicing

Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any
deformation

The mains cables must be in impeccable condition and should be replaced immediately when even a small
problem is detected

In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.

The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.

Clean with soft cloth using normal glass cleaning fluid.

Always dry the parts carefully.

Clean the external optics at least every 20 days. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified

TECHNICAL SPECIFICATION

Rated voltage
Rated power
LED
Fuse
Control Signal
Channel
Function
Dimensions per unit
Weight (per unit)
The specifications are typical. The actual values can slightly change from one unit to the other. Specifications can be
changed without prior notice.
: AC100～240V 50/60Hz
: 40W
: 186x10mm (42x Red, 42x Green,42x Blue, 60xWhite)
: F2A
: DMX signal
: 7Channels
: DMX, IR, Auto, Sound active and Master-Slave.
: 218 x 218 x 72mm
: 1.2kg