Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
cOnnEctIOn
connect the line outputs of your input device to the suitable input connectors of the PLI04 using high quality
shielded cables. The PLI04 offers several options: 6.3mm Jack sockets suitable for mono or stereo connec-
tors, cinch/Rca sockets or a stereo 3.5 jack socket.
We do not advise the simultaneous use of different connector types as this can lead to interferences.
connect the outputs of the PLI04 to the microphone inputs of your mixer using balanced and shielded micro-
phone cables. For stereo signals you will need two channels on the mixer - remember to pan the channels
left and right to obtain a true stereo signal.
NOTe: IF yOU aRe ONLy USING ONe INPUT SOcKeT, Be SURe TO USe THe Red Rca SOcKeT aS THIS IS
THe ONe cONNecTed TO THe HOUSING GROUNd.
8
SPEcIFIcAtIOnS
Product type:
Passive dI-box, stereo unit, transformer balanced outputs,
mono switch
Type:
passive
Inputs:
2 x 6.3 mm TRS-Jack, Tip = +phase (hot), Ring = -phase (cold),
Sleeve = screening, ground
2 x Rca phono sockets and 1x 3.5 mm stereo jack
Input impedance:
6k ohms at 600 ohms load
Input level:
6dBu @ 30Hz / 0.05 % THd
16dBu @ 30Hz / 0.33 % THd
all measurements taken with 200 ohms source
Outputs:
2 x XLR male, Pin 1 ground, Pin 2 pos. phase (hot),
Pin 3 neg. phase (cold)
Transformer balanced
Output impedance:
600 ohms
Grain reduction input to output:
10dB,
Transformer ratio:
3.16 : 1
Frequency response:
20Hz - 20kHz ± 0.5dB
Phase response:
less than 3°degree deviation
Mono switch 3 position ground
lift, ground, soft ground
lift switch:
Housing material:
Sheet steel
dimensions (W x H x d):
125 mm x 95 mm x 35 mm
9
Publicidad
Tabla de contenido
