Bestway FAST SET POOL El Manual Del Propietario página 7

FILLING POOL WITH WATER
ATTENTION: Do not leave pool unattended while filling with water.
Pool walls will rise as you fill with water. (See Fig. 7)
The pool liner must extend evenly around the outside of the inflatable ring when filling the pool with water.
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to ensure the pool is level. If pool is
not level, drain water and re-level ground by digging out. Never attempt to move the pool with water
in it, serious personal injury or damage to the pool may result.(See Fig. 9)
NOTE: Your pool may contain up to xxxxx liters / xxxx gallons which equals xxxxx pounds of pressure.
If your pool has any bulge or uneven side then the pool is not level, the sides may burst and the water
may discharge suddenly causing serious personal injury and/or damage to property.
3. Fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for secure fit.
5. Fill pool until water capacity is 80%, up to the bottom of the inflated ring of the pool so that the sides are smooth and firm. DO NOT OVERFILL as
this could cause the pool to collapse. In times of heavy rainfall you may need to empty some of the water to ensure the level is correct. (See Fig. 8)
6. Check pool for any leaks at valves or seams, check ground cloth for any evident water loss. Do not add chemicals until this has been done.
7. In the event of a leak, patch your pool using the patch kit provided. Refer to the FAQ's for further information.
Fig. 8
Proper Water Level
Pool Maintenance
If you do not adhere to the maintenance guidelines below, your health might be at risk, especially that of your children.
NOTE: The filter pump is used to circulate the water and to filter small particles to keep your water free of suspended dirt particles. In order to keep
your pool water clean and hygienic you must add chemicals.
To keep your pool clean:
1. Contact your local pool supply shop for advice and purchase of chemicals and PH kits.One of the most important factors to increase the life of the liner is to
keep continuosly clean and healty water. Please follow strictly the instructions from professional technicians for the water treatment through the use of chemicals.
2. Locate a bucket of water next to pool to clean users' feet before entering pool.
3. Cover the pool when not in use.
4. Skim pool regularly to avoid settled dirt.
5. Change filter cartridge in filter pump every 2 weeks.
6. Gently clean any scum from below the top ring with a clean cloth.
7. To improve the water quality we suggest to use Bestway accessories like skimmer, maintenance kits. Please visit our website www.bestway-
service.com or contact your pool supplier. Please be careful in case of rain water, kindly check that the water level is not higher than the expected
one. If so, please act consequently.
Proper maintenance can maximize the life of your pool.
ATTENTION: Do not use pump when pool is in use.
Repair
If your pool is damaged, use the repair patch. -see FAQ's for instructions.
Dismantling
1. Unscrew the drain valve cap on the outside of the pool counter clockwise and remove.
2. Connect the adaptor to the hose and put the other end of the hose in the area where you are going to drain your pool. (Check local regulations for
drainage by-laws).
3. Screw control ring of the hose adaptor onto the drain valve clockwise. The drain valve will be open and water will start to drain automatically.
ATTENTION: Water flow can be controlled with the control ring.
4. When draining is finished, unscrew the control ring to close the valve.
5. Disconnect the hose.
6. Screw the cap back onto the drain valve.
7. Deflate the top ring.
8. Air dry pool.
ATTENTION: Do not leave the drained pool outside.
Storage
1. Please remove all the accessories and spare parts of the pool and store them clean and dry.
2. Once pool is completely dry, sprinkle with talcum powder to prevent pool from sticking together, fold pool carefully. If pool is not completely dry,
mould may result and will damage the pool liner.
3. Store liner and accessories in a dry place with a moderate temperature between 5ºC / 41ºF and 38ºC / 100ºF.
Fig. 9
Flat, Level Ground - CORRECT
7
Fig. 7
Bumpy, Sloping Ground - INCORRECT
Bestway
®
S-S-000662