Approvals; Materials Of Construction - Parker LCMS15 Guia Del Usuario

2.2 Approvals

Safety and Electromagnetic Compatibility (EMC)
LISTED
LABORATORY
EQUIPMENT 84NA

2.3 Materials of Construction

Columns and Storage Vessels
Facia and Covers
Chassis
Seal Materials
Display Bezel
Display Facia
Compression fittings
Pressure Gauge
Coalescing Filter
Solenoids
Paint
Adsorbants¹
Adsorbants²
Heat Exchanger
Flow Controller
End Caps
Fittings
Castor Wheel
4
This equipment has been tested and complies with the following European Standards:
EN61010-1: 2001 — Safety Requirements for Electrical Equipment for Measurement, Control, and Laboratory use - Part 1:
General Requirements.
EN61326: 2006 — Electrical Equipment for Measurement, Control, and Laboratory use, EMC Requirements.
EN61000-3-2: 2006 — Electromagnetic compatibility (EMC) Limits. Limits for harmonic current emissions (equipment input
current = 16 A per phase).
EN61000-3-3: 1995 (+A1: 2001 + A2: 2006) — BS EN 61000-3-3:2008 Electromagnetic compatibility (EMC). Limits. Limitation of
voltage changes, voltage fluctuations and flicker in public low-voltage supply systems, for equipment with rated current = 16 A per
phase and not subject to conditional connection.
This equipment has been tested to and complies with the following standard:
UL 61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
CAN/CSA C22.2 No.61010-1 2nd Edition, "Electrical Equipment for Laboratory Use; Part 1: General Requirements.
Extruded high tensile aluminium alloy, grade EN AW-6063 T6
Noryl FN150 (R4G334/ AE251/1 Trimite coated)
Mild Steel (Epoxy Powder Coated)
Nitrile, Viton, EPDM, PTFE (tape)
PA-765 ABS
Polyester film (Lumirror S10)
Brass
ABS Plastic casing and dial, brass connector and movement
Aluminium Housing
Brass
All external surface epoxy powder coated
CMS (carbon molecular sieve)
AA (activated alumina)
Copper Tube
Aluminium, brass, stainless steel, nitrile and flurocarbon
Cast aluminium – BS EN 1706-1998 ENAC 44100
Nickel plated brass
Zinc chromed pressed steel and polypropylene