Problems And Solutions - Climadiff CVV Serie Manual De Utilización

 If the appliance is disconnected or if there is a power cut, you must wait three to five minutes before re-
starting. If you try to re-start before this time, the compressor will only re-start after 3 to 5 minutes (if the
temperature requires).
 When switching on for the first time or following a prolonged shutdown, it is possible that when re-starting,
the temperatures selected and those displayed are not the same. This is normal. It will take a few hours
before they stabilise.
10. IF YOU NEED TO MOVE YOUR WINE CELLAR
 First, disconnect your cellar
 Remove all the bottles from the cellar and secure moving parts
 To avoid damaging the levelling screws on the feet, screw them tightly into the base
 Move the appliance in an upright position (preferably) or take note of the direction in which the
appliance may be laid down by looking at its packaging.
11. IN THE EVENT OF A BREAKDOWN
Despite the care we take during production, a breakdown can never be totally ruled out. Before contacting
your retailer's after-sales department, please check that:
 The appliance is properly plugged in
 There is not a power cut in progress
 The breakdown is not one of those described in the table at the end of this manual
IMPORTANT: if the power cable supplied is damaged, it must be replaced by the manufacturer, a
service centre approved by the brand or the retailer. In all events, it must be replaced by qualified
personnel in order to avoid any risk of injury.
I
F THESE CHECKS REVEAL NOTHING
Unplug the appliance before carrying out any maintenance or

12. PROBLEMS AND SOLUTIONS

You can solve many simple problems with your wine cellar yourself, thus avoiding having to contact your
after-sales department. Try the following suggestions.
PROBLEM
The cellar will not start
The cellar does not cool sufficiently
,
THEN CONTACT YOUR RETAILER
CAUTION!
repair work.
The cellar is not plugged in.
If your wine cellar is in an unheated room, refer to the
section "Winter Kit".
The fuse in your electrical installation has blown.
The thermostat position is set to provide insufficient
cooling: adjust it.
'
A -S D
S FTER ALES EPARTMENT
POSSIBLE CAUSES
.
37