Operation - Beurer EM 35 Instrucciones Para El Uso

Description of the display symbols
A Battery status display: flashes if the battery is flat
B Intensity:
C Pause symbol:
D Timer:
E Key:
F Program:
A B

4. Operation

Inserting batteries
If the battery symbol in the display flashes, the batteries are flat and must be replaced. The opera-
ting unit must be removed from the holder on the belt to insert or replace batteries.
– Release the magnetic connector by pulling the device away from the belt.
The magnetic connector of the two contact buttons clicks out noticeably.
– Pull the device upwards out of the holder.
– Remove the battery compartment lid by pressing and sliding in the direction of the arrow.
– Insert the batteries observing the markings in the battery compartment. Ensure correct battery
polarity.
Note:
– Rechargeable batteries cannot be used for this device.
– If the device is not in use, we recommend keeping the device separate from the belt. If the device
is not needed for a long period, we recommend first removing the batteries.
– The empty, completely flat batteries must be disposed of through specially designated collection
boxes, recycling points or electronics retailers. You are legally required to dispose of the batteries.
– The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
– For environmental reasons, do not dispose of the device in the household waste at the
end of its useful life. Dispose of the unit at a suitable local collection or recycling point. Dis-
pose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for
waste disposal.
Attaching the belt
Before each training session you should ensure that your skin is clean and free of creams or oils.
Only then can the device work optimally.
– Lay the belt down with the electrodes facing towards you.
– Moisten the electrodes and your stomach with water. Make sure that the electrode surfaces are
evenly moistened to avoid high voltage points on your skin during subsequent training.
set intensity levels 0 - 40
flashes if pause is activated
remaining time for the program started
key lock is activated
selected program with the number of training cycles already
completed
C D E F
14