Engine filter cleaning
Between the tank and the main body of the vacuum cleaner there is a filter
whose function is to prevent the possible particles entering the engine from
entering the engine. To clean it gently pull it out (so as not to damage it) and
wash it with plenty of water, do not use abrasive or solvent-containing products,
then let it dry on its own.
To place it, you must match the four slots of the filter with the four tabs located
on the main body of the vacuum cleaner.
Attention: Never connect the vacuum cleaner to the mains without all filters
being correctly put in place.
Vacuum cleaning, maintenance and storage
Check the condition of the parts and accessories (tubes, nozzles, filters,
etc.) with some frequency, if necessary replace them.
Clean the plastic surface with a slightly damp cloth. Never use abrasive or
solvent-containing products and do not immerse the vacuum in water or
any other liquid.
To store the vacuum cleaner you can use the wall bracket.
THERMAL PROTECTOR
When the tank is full, the clogged filters or an accessory is clogged (extension
tube, nozzle, etc.), it will hinder the passage of air if a prolonged time elapses
(without solving the cause that caused the obstruction) and with the vacuum
cleaner On, the vacuum motor will get too hot.
The vacuum cleaner has an internal protection (thermal switch) that can be
activated when the engine is overheated, which will cause the motor to
automatically stop.
If this happens, unplug the vacuum cleaner, solve the cause of the engine
overheating (cleaning the tank, filters or unblocking the clogged accessory) and
then wait until the engine cools.
11