Before Starting The Equipment; Operation - EINHELL TE-CD 18-2 i Manual De Instrucciones Original

5. Before starting the equipment

Be sure to read the following information before
you use your cordless screwdriver for the fi rst
time:
1. Charge the battery pack with the charger
supplied. An empty battery pack requires a
charging period of approximately 1 hour.
2. Only ever use sharp drill bits and screwdriver
bits which are suitable for the purpose and in
faultless condition.
3. Always check for concealed electric cables
and gas and water pipes when drilling and
screwing in walls.

6. Operation

6.1 Charging the battery (Fig. 2-3)
1. Remove the battery pack (5) from the handle
(Fig. 2) by pressing the pushlock buttons (8)
on the right and left side.
2. Check that your mains voltage is the same
as that marked on the rating plate. Insert the
power plug of the charger (6) into the mains
socket outlet. The green LED will then begin
to shine.
3. Push the battery pack (5) onto the battery
charger. The red LED will blink slowly and the
green LED will shine, indicating that the batte-
ry pack is being charged.
4. Both LEDs will shine when the charging is
completed.
If the green LED and the red LED shine conti-
nuously while the battery pack is inserted, the
charging temperature is either too high or too low.
- In this case, pull out the mains plug of the
charger and charge the battery in an envi-
ronment in which the temperature is either
warmer or colder.
If the red LED blinks quickly and the green LED
shines, the battery pack is too cold or too warm.
- In this case, pull out the mains plug of the
charger and store the battery in a warmer
place or let it cool down and try again.
If the fault still occurs, the battery pack is defec-
tive.
- In this case pull out the charger plug immedi-
ately and remove the defective battery pack.
- Do not use the defective battery pack again.
Anl_TE_CD_18_2_i_SPK7.indb 20 Anl_TE_CD_18_2_i_SPK7.indb 20
GB
If the battery pack fails to become charged, ple-
ase check
•
whether there is voltage at the socket-outlet
•
whether there is proper contact at the char-
ging contacts on the charger.
If the battery still fails to become charged, please
return
•
the charger
•
the battery pack
to our Customer Service Department.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the power of the cordless equipment
drops.
6.2 Torque setting (Fig. 4 / Item 1)
Important! The tool must be at a standstill
when you set the torque with the setting ring.
The cordless hammer drill/screwdriver is fi tted
with a mechanical torque selector.
The torque for a specifi c size of screw is selected
with the set-collar (1). The correct torque depends
on several factors:
•
on the type and hardness of material in ques-
tion
•
on the type and length screws used
•
on the requirements needing to be met by the
screwed joint.
The clutch disengages with a grating sound to
indicate when the set torque is reached.
6.3 Drilling/hammer drilling (Fig. 4)
•
For drilling purpose, adjust the torque setting
(1) to the setting "Drill".
•
For hammer drilling purpose, adjust the
torque setting (1) to the setting "Hammer".
In the drill and hammer drill settings the slip cou-
pling is non-functional. The maximum torque is
available for drilling and hammer drilling.
- 20 -
17.12.13 10:15 17.12.13 10:15