Billy Goat QVEU Serie Manual Del Propietário página 9

QVEU PUSH Owner's Manual
TROUBLESHOOTING
Problem
Abnormal vibration
Will not vacuum or has poor
vacuum performance
Engine will not start
Engine is locked, will not pull over
Nozzle scrapes ground in lowest
height setting
Part No 831508
Possible Cause
Loose or out of balance impeller or loose engine.
Dirty debris bag. Nozzle height set too high or low.
Hose kit cap missing. Clogged nozzle or exhaust.
Excessive quantity of debris.
Stop switch off. Throttle in off position. Engine not in
full choke position. Out of gasoline. Bad or old
gasoline. Sparkplug wire disconnected. Dirty air
cleaner. Low oil (honda only).
Debris locked in impeller. Engine problem.
Nozzle height out of adjustment.
Check impeller and replace if required.
Check engine.
Clean debris bag. Shake bag clean or
wash. Adjust nozzle height. Check for hose
kit cap. Unclog nozzle or exhaust. Allow air to
feed with debris.
Check stop switches, throttle, choke
position and gasoline. Connect spark plug
wire. Clean or replace air filter. Or contact a
qualified service person.
See page 6. Contact a engine service dealer
for engine problems.
Adjust nozzle height (See Nozzle height fine
adjustment for hard surfaces on page 6.
9
Solution
Form No F102715F