Beamz PLS10 Jellyball Manual De Instrucciones página 5

OPERATION
Via the on/off switch, you can switch the fixture on and off.
Play music through BT connection
After switch on the fixture, you can connect it through BT.
1. Open BT function on your smart device, you will find device name "PSL10"available.
2. Connect to this device and it's now ready to play music through BT with speaker.
Play music through USB device.
1. Insert a USB device with music inside into the USB port.
2. The play of the music will start automatically.
3. Operate the music through IR remote.
Note: The fixture support USB devices with file system FAT32. Audio format-MP3, for other audio format, the fixture do not
support or cannot be decoded well.
Speaker on/off
Switch between BT and USB
Mute function
Play/Pause
Previous/Next song
Equalizer
Speaker volume up/down
Repeat
No function
Select a song
CHARGING THE FIXTURE
The fixture is designed with a Li-ion 3.7V 2000mAh 7.4Wh rechargeable battery inside. Please use a 5V charger to charge the
fixture. It takes three hours to charge from 0-100%.
FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output.
Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding
can cause greater accumulation of dirt on the unit's optics.
•
Make sure the area below the installation place is free from unwanted persons during servicing
•
Housings, fixations and installations spots( ceiling, truss, suspensions) should be totally free from any deformation
•
The mains cables must be in impeccable condition and should be replaced immediately when even a small problem is
detected
•
In order to protect the fixture from overheat the cooling fans (if any) and ventilation openings should be cleaned
monthly.
•
The interior of the fixture should be cleaned annually using a vacuum cleaner or air-jet.
•
Clean with soft cloth using normal glass cleaning fluid.
•
Always dry the parts carefully.
•
Clean the external optics at least every month. Clean the internal optics at least every 30/60 days.
ATTENTION: We strongly recommend internal cleaning to be carried out by qualified worker!
5