Emptying Liquid Waste From The Tank; Maintenance And Repair - Mac allister MWDV20L Manual De Instrucciones Y De Seguridad

EN

EMPTYING LIQUID WASTE FROM THE TANK

Use special care when emptying heavily loaded tanks. Your Wet/Dry Vacuum may be emptied of
waste by removing the tank cover. To empty, stop the motor and remove the plug from the wall
receptacle. Remove the tank cover and deposit the liquid waste contents into a suitable drain.
Your Wet/Dry Vac also comes standard with a convenient tank drain. NOTE: THE TANK DRAIN
FEATURE IS NOT STANDARD ON ALL MODELS. Simply remove the drain cap and empty the
liquid contents into a suitable drain. After the tank is empty, return the cover to its original position.
To continue use, plug the cord into the wall receptacle and start the motor.
REPAIR OR REPLACEMENT OF PARTS
Never attempt any service to the unit unless the power cord is disconnected from the power
receptacle.
These units incorporate electrical components that can be replaced. It is recommended that
repair or part replacement be performed by a skilled technician. Only use original manufacturer
recommended replacement parts. If the receptacle cover becomes detached, broken or damaged,
or clear boot over switch would be damaged or missing, discontinue operation and have the unit
repaired.

Maintenance and Repair

The vacuum cleaner does not require lubrication or supplementary maintenance. Before storing
the vacuum cleaner, always empty and clean the tank. Never leave any liquids standing in the
tank for an extended period of time. Clean the foam sleeve in order to avoid clogging from debris.
Never use water or chemical cleaning products with detergent to clean the vacuum cleaner. Use a
dry cloth. If the supply cord needs replacing, the task must be carried out by the manufacturer, the
manufacturer's agent, or an authorised service centre in order to avoid a safety hazard.
20L 1100W WET/DRY VACUUM CLEANER
10