Rockford Fosgate RFX9020 Instalación Y Funcionamiento página 18

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

T
ROUBLESHOOTING
NOTE: If the error still continues after doing one of the easy remedies, before taking the unit to a
service dealer, try resetting the system by pressing the reset button.
General
S
YMPTOM
Source Unit does
not turn on
No backlight
illumination
Speakers pop
when turning
Source Unit
On/Off
Tuner fails to tune
any radio stations
Tuner has poor
reception
Disc will not load
into Source Unit
(also see error
codes)
Disc will not eject
(also see error
codes)
ERROR 3
(Loading Error)
18
D
IAGNOSIS
Voltage applied to Red and
Yellow wires is not between
10.8 and 16 volts or there is no
voltage present
Unit is not properly grounded
Detachable faceplate not
properly connected
Auto antenna and remote B+ are
not configured properly
Bad component in the signal
chain
Antenna is disconnected
Antenna is disconnected or not
properly grounded to vehicle
Antenna cable is intermittent or
damaged
Antenna is wrong type for
AM/FM frequencies
Voltage applied to Red and
Yellow wires is not between
10.8 and 16 volts or there is no
voltage present
Voltage applied to Yellow wire is
not between 10.8 and 16 volts
or there is no voltage present
Foreign objects are preventing
the disc from loading
Loading area in mechanism and
loading motor (or driving circuit)
is defective
R
EMEDY
Check battery, connections and fuses and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center.
Check wiring and repair as necessary
Detach faceplate and reinstall into chassis
Check wiring and repair as necessary. Refer to
"Wiring the System" section of this manual for
further information
Check connections and bypass all
components between the source unit and the
amplifier. Connect one component at a time to
determine the culprit. Connect this component
to the Blue wire and check for pops. Repair or
replace component as necessary
Check connections and repair as necessary
Check connections and installation of antenna
and repair or replace as necessary
Disconnect antenna and test with known
working antenna. If tuner works, check
installation and repair antenna as necessary
Consult your local Authorized Rockford
Fosgate Dealer for proper antenna selection
Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
Check battery, connections and fuses, and
repair or replace as necessary. If voltage is
above +16 volts, have the electrical system
inspected by an authorized car service center
Check CDP mechanism load area by
removing faceplate and repair as necessary
Repair the mechanism and loading motor
(or driving circuit)

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Rfx9120Rfx9120r

Tabla de contenido