Sylvania LD370SS8 M2 Manual De Instrucciones página 38

O
PERATING DVD
Stereo Sound Mode Stereo Sound Mode
CD VCD
This unit allows you to select a sound mode during CD playback.
During playback, press [AUDIO] repeatedly until the
desired sound mode appears.
• Each time you press [AUDIO], the sound mode
changes as example below.
STEREO (stereo sound with left and
L-ch
R-ch
Note:
• Virtual surround cannot be changed when the sound mode
is set to either "L-ch" or "R-ch".
Virtual Surround Virtual Surround
DVD CD
You can enjoy virtual surround on your existing 2 channel stereo system.
1
During playback, press [MODE] repeatedly until "
appears.
2
Press [ENTER] to select the sound level.
1 : Natural effect.
2 : Emphasized effect.
OFF : No effects (original sound).
3
Press [BACK/RETURN] to exit.
Note:
• The setting will be kept even if the unit is turned off.
• For audio CD and video CD, virtual surround will not be
effective if the sound mode is set to something other than
"STEREO".
Refer to "Stereo Sound Mode".
• Turn down the level or select "OFF" if the sound is distorted.
38
EN
STEREO
right channels)
(left channel sound only)
(right channel sound only)
VCD MP3
OFF
1
Marker Setup Marker Setup
DVD CD
This feature allows you to assign a specific point on a disc to be called back later.
To set a marker
1
During playback, press [SEARCH MODE] repeatedly
until " " appears.
2
Use [Cursor s / B] to select an available marker within
30 seconds.
3
When the playback reaches the point at which you
want to set a marker, press [ENTER].
• Marker is now set.
4
Press [BACK/RETURN] to exit.
"
To return to the marker later
1
To select a desired marker, repeat steps 1-2 in
"To set a marker".
2
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
Note:
• Marker search menu will disappear in about 30 seconds
when there is no input.
• You can mark up to 10 points.
• To clear a marker, select the marker to be cleared at step 2 in
the section "To set a marker" or
"To return to the marker later", and then press [CLEAR].
• Ejecting the disc or turning off the power will erase all
markers.
• Selecting " " at step 2 in the section "To set a marker" or
"To return to the marker later" will also erase all markers.
VCD
w/o PBC
e.g.) DVD
e.g.) DVD