Optional Accessory - Makita DUM604 Manual De Instrucciones

7. Tighten the two screws firmly with a screwdriver.
1
► 1 . Screws
8. Place the undercover so that
cover is aligned with
9. While pressing the undercover, turn the under-
cover clockwise until
with on the lock lever.
on the under-
on the lock lever.
on the undercover is aligned
10. Make sure that the lock lever fits in the groove on
the undercover.
1
► 1 . Lock lever
CAUTION:
Never use the tool without install-
ing the undercover.
11. Remove the blade cover, and then turn on the tool
to check if the tool works properly.
NOTICE:
If the shear blades do not operate prop-
erly, the blades are not engaging the crank prop-
erly. Remove the blades and install them again.
Installing or removing the chip
receiver

Optional accessory

CAUTION:
When installing or removing the
chip receiver, always wear gloves and attach the
blade cover so that your hands and face do not
directly contact the blade.
The chip receiver gathers discarded leaves and makes
clean-up afterward much easier. It can be installed on
either side of the tool.
To install the chip receiver, press it against the shear
blades so that the hooks fit into the holes of the shear
blades.
► 1 . Hooks 2. Holes
14 ENGLISH
1
2