Alpine IVA-W205 Manual De Operación página 69

Indication for DVD/Video CD
• No disc is inserted.
- Insert a disc.
• Although a disc is inserted, "NO DISC" is displayed and the unit
does not start to play or eject the disc.
- Remove the disc by following these steps.
Press for at least 3 seconds.
• Head unit buttons and remote control operation are not possible.
- For some discs or playing modes, certain operations are not
possible. This is not a malfunction.
• Protective circuit is activated to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
- Leave the power OFF until the temperature decreases and then
turn the power ON again.
• Disc does not match regional code number.
- Load a disc that matches the regional code number.
• PAL disc is loaded.
- Load an NTSC disc.
• Mechanism error.
1) Touch [ ] of DISC on the EJECT/TILT screen and eject the
disc.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, touch [
of DISC on the EJECT/TILT screen again.
If the error indication still does not turn off after touching
[ ] of DISC on the EJECT/TILT screen for a few times,
consult your Alpine dealer.
• Scratched disc, contaminated disc/poor recording/disc
incompatible with this unit.
- Touch [ ] of DISC on the EJECT/TILT screen.
- Change the disc.
• The DVD setup operation was attempted when a disc is inserted
in the unit.
- Eject the disc before the DVD setup operation.
Indication for CD changer
• Protective circuit is activated due to high temperature.
- The indicator will disappear when the temperature returns to
within operation range.
• Malfunction in the CD Changer.
- Consult your Alpine dealer. Press the magazine eject button
and pull out the magazine.
Check the indication. Insert the magazine again.
If the magazine cannot be pulled out, consult your Alpine
dealer.
• Magazine ejection not possible.
- Press the magazine eject button. If the magazine does not eject,
consult your Alpine dealer.
• A disc is left inside the CD Changer.
- Press the eject button to activate the eject function. When the
CD Changer finishes the eject function, insert an empty CD
magazine into the CD Changer to receive the disc left inside
the CD Changer.
• No magazine is loaded into the CD Changer.
- Insert a magazine.
• No indicated disc.
- Choose another disc.
]
67
-EN