Operation - Greenlee AMT Serie Manual De Instrucciones

Operation

Electric shock hazard:
• This tool was tested to meet OSHA
1910.269 (dry test) when manufac-
tured. It must be properly cleaned
and maintained to ensure contin-
ued non-conductive properties.
When using this unit near energized
electrical lines, use only certified
non-conductive hoses and proper
personal protective equipment.
• Keep fiberglass extension clean
and dry when working around
energized electrical lines.
Accumulated oil or dirt reduces the
insulating properties of the tool.
Failure to observe these warnings
could result in severe injury or death.
Skin injection hazard:
• Do not use hands to check for leaks.
• Do not hold hose or couplers while
the hydraulic system is pressurized.
• Depressurize the hydraulic system
before servicing.
Oil under pressure easily punctures
skin causing serious injury, gangrene
or death. If you are injured by escap-
ing oil, seek medical attention
immediately.
Saw body, bar, blade and other
components will be hot during and
after use. Use care when handling the
saw. Hot surfaces can cause serious
burns.
Failure to observe this warning could
result in severe injury or death.
Wear a hard hat when using this tool.
Failure to observe this warning could
result in severe injury or death.
Greenlee
Long-Reach Chain Saws (Foam-filled)
14
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Before operating the saw, read and
understand the following explanations
in this manual:
• Pull-In
Pull-in can occur when the blade
at the bottom of the bar contacts
a foreign object, such as a nail, or
when the blade is pinched in the
cut.
The saw will be suddenly and force-
fully pulled away from the operator.
• Push-back
Push-back can occur when the
blade at the top of the bar contacts
a foreign object, such as a nail, or
when the blade is pinched in the cut.
The saw will be suddenly and
forcefully pushed back toward the
operator.
• Kickback
Kickback can occur when the
chain at the guide bar tip contacts
anything. The bar of the saw will
travel upward and back, toward the
operator.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris or hydraulic oil.
Wear hearing protection when using
this tool.
Long-term exposure to high noise
levels could result in hearing loss.