LG 32LH550B Manual Del Usuario página 13

Wireless LAN module
(WN8122E1) Speci cations
Standard IEEE 802.11a/b/g/n
2400 to 2483.5 MHz
Frequency
5150 to 5250 MHz
Range
5725 to 5850 MHz
802.11a: 16.5 dBm
802.11b: 16 dBm
Output Power
802.11g: 15.5 dBm
(Max.)
802.11n - 2.4 GHz: 15.5 dBm
802.11n - 5 GHz: 16.5 dBm
• As band channels can vary per country, the
user cannot change or adjust the operating
frequency. This product is con gured for the
regional frequency table.
• For consideration of the user, this device
should be installed and operated with a
minimum distance of 20 cm (7.8 inches)
between the device and the body.
• Contains FCC ID: BEJWN8122E1 /
Contains IC: 2703H-WN8122E1
Regulatory
FCC NOTICE
(For USA)
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment o and on, the user is encouraged
to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and the receiver.
- Connect the equipment to an outlet on a circuit
di erent from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that
may cause undesired operation of the device. Any
changes or modi cations in construction of this
device which are not expressly approved by the
party responsible for compliance could void the
user's authority to operate the equipment.
11