Kohler STERLING 1042 Guía De Instalación Y Cuidado página 9

Fregadero de cocina de borde terminado o bajo cubierta
Tabla de contenido

Publicidad

Installation
4
Wood Frame
Cadre en bois
Estructura de
madera
Clearance for the Sink Basin
Dégagement pour cuve d'évier
Espacio libre para el fregadero
NOTICE: To ensure the weight of the sink is properly supported, the entire perimeter
of the sink rim must rest on the wood frame.
Measure the cabinet opening where the sink will be installed. Plan for adequate
clearance between the faucet handles and the backsplash or finished wall.
Construct a wood frame for the inside of the cabinet. Allow adequate clearance for
the faucet valving and sink basin. Ensure the frame will support the entire sink
rim.
NOTE: The frame should be located so that once the sink is installed, the top of the
sink rim will be flush with the top of the cabinet walls. If needed, shims can be used
to bring the sink rim flush with the cabinet walls.
NOTICE: Use proper fasteners and techniques to ensure that the wood frame will
support a minimum of 300 lbs (136 kg). Locate the fasteners for easy access in the
event the sink needs to be removed.
Position the wood frame within the cabinet and secure. Locate the fasteners for
easy access in case the sink needs to be removed.
Apply a 1" (2.5 cm) bead of sealant at each corner of the wood frame where it will
contact the sink.
Installation
NOTICE: Pour assurer un soutien adéquat du poids de l'évier, le périmètre complet
du rebord de l'évier doit reposer sur le cadre en bois.
Mesurer l'ouverture du meuble où l'évier sera installé. Prévoir suffisamment de
dégagement entre les poignées de robinet et le dosseret ou le mur fini.
Construire un cadre en bois pour la partie intérieure du meuble. Laisser un espace
adéquat pour les valves de robinet et le bassin de l'évier. S'assurer que le cadre
supportera le rebord entier de l'évier.
REMARQUE: Le cadre devrait être localisé de manière à ce qu'une fois l'évier
installé, le dessus du rebord de ce dernier soit à égalité avec le dessus des murs du
meuble. Si besoin, des cales peuvent être utilisées pour amener le rebord de l'évier à
égalité avec les murs de meuble.
Sterling
Apply silicone sealant.
Appliquer du mastic à la silicone.
Aplique sellador de silicona.
Sink Rim Flush with Cabinet
Rebord d'évier à égalité avec le meuble
Borde del fregadero al ras con el gabinete
Cabinet Wall
Meuble mural
Pared del gabinete
Shim Location
Wood Frame
Emplacement câle
Cadre en bois
Lugar para cuñas
Estructura de madera
9
Sink
Évier
Fregadero
1106144-2-C

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sterling 1043

Tabla de contenido