Timer Feature (Kitchen Timer/Stand Time/Delay Start) - Panasonic INVERTER NN-P295 Instrucciones De Operación E Instalación

This feature allows you to program the oven as a kitchen timer.
It can also be used to program a standing time after cooking is
completed and/or to program a delay start.
To Use as a Kitchen Timer:
Example: To count down 5 minutes.
1.
• Press Timer.
2.
• Set desired amount of time using
number pads.
(up to 99 minutes and 99 seconds).
3.
• Press Start.
➤Time will count down without oven
operating.
To Set Stand Time:
Example: To cook at P6 power for 3 minutes, with stand
time of 5 minutes.
1.
• Enter the desired Power Level (see
page 11 for directions).
Press 5 times
2.
• Set desired cooking time using num-
ber pads.
3.
• Press Timer.
4.
• Set desired amount of Stand Time
using number pads. (up to 99 minutes
and 99 seconds)
5.
• Press Start.
➤Cooking will start. After cooking,
stand time will count down without
oven operating.
Timer Feature
CAUTION:
If oven lamp is lit while using the timer feature, the oven is
incorrectly programmed. Stop oven immediately and
re-read instructions.
To Set Delay Start:
Example: To delay the start of cooking for 5 minutes, and
1.
2.
3.
Press 5 times
4.
5.
NOTE:
1. When each stage finishes, a two-beep signal sounds. At the
end of the program, the oven will beep five times.
2. If the oven door is opened during Stand Time, Kitchen Timer
or Delay Time, the time on the display will continue to count
down.
3. Stand time and Delay start cannot be programmed before
any automatic Function. This is to prevent the starting tem-
perature of food from rising before defrosting or cooking
begins. A change in starting temperature could cause inac-
curate results.
18
cook at P6 power for 3 minutes.
• Press Timer.
• Enter desired amount of delay time
using number pads. (up to 99 minutes
and 99 seconds)
• Enter the desired Power Level (see
page 11 for directions).
• Set desired cooking time using num-
ber pads.
• Press Start.
➤Delay time will count down. Then
cooking will start.