External Speaker/Microphone Jack - Cobra microTALK PR 955 DX Instrucciones Operativas

O P E R AT I O N
Talking to Another Person
1. Press and hold the
TALK button.
TALK button
2. With the
microphone about
2 inches (5 cm)
from your mouth, speak in a normal voice.
3. Release the button when you're finished
talking and listen for a response.
You cannot receive incoming calls
while pressing the TALK button.
"Roger Beep"
Confirmation Tone
Your listener will hear an audible tone when
you release the TALK button. This alerts the
other party that you are finished talking and it
is OK for them to speak. (NOTE: The Roger
Beep can be turned off and on, see page 11.)
Listening for a Response
When you are finished talking:
1. Release the TALK button to receive incoming
transmissions. Your microTALK is always
®
in listening mode while the TALK button is
not pressed.
5
ENGLISH
2. Adjust the volume by rotating the
ON-OFF/VOLUME switch.
ON/OFF
VOLUME
SWITCH
Illuminating the Display
1. Press and release the LIGHT/MAX RANGE
button to illuminate the display for
10 seconds.
LIGHT/MAX RANGE
button
Auto Squelch/Maximum Range
Your microTALK ® radio is equipped with
Auto Squelch, which automatically shuts
Off weak transmissions and unwanted noise
due to terrain, conditions, or if you've
reached your maximum range limit.
You can temporarily turn Off Auto Squelch or
turn On Maximum Range Extender, allowing
all signals to be received and extending the
maximum range of your radio.
To temporarily turn Off Auto Squelch:
1. Press the LIGHT/MAX RANGE button less
than five (5) seconds. If you hear two (2)
beeps, you have turned the Maximum
Range Extender On (see above).
ENGLISH
LIGHT/MAX RANGE
button
To turn Maximum Range Extender On:
1. Press and hold the LIGHT/MAX RANGE
button for at least five (5) seconds until
you hear two (2) beeps which indicates
the Maximum Range Extender is On.
To turn Maximum Range Extender Off:
1. Press and release the LIGHT/MAX RANGE
button or change channels.
Using the Lock Function
The Lock function locks the CHANNEL, MODE
and ENTER buttons to prevent accidental
operation. To use the Lock function:
1. While in Standby mode, press and hold
the LOCK button
LOCK button
for one second.
The Lock icon will
blink when the unit
is locked. Buttons
that are NOT
locked are the
CALL, LIGHT/MAX
RANGE, and TALK
buttons, which are
all fully functional
while the unit is locked.
O P E R AT I O N
2. To "unlock" buttons, press and release
the LOCK button again. The Lock
icon disappears and all buttons will
be unlocked.
External Speaker/
Microphone Jack
Your microTALK ® radio can be fitted with an
external speaker/microphone, freeing your
hands for other tasks. (See page 17 for
optional accessories.)
To attach an external speaker/microphone:
1. Open the SPKR/MIC tab on top of
the unit.
2. Insert the plug into the SPKR/MIC jack.
(CAUTION: Do not use an external
speaker/microphone with common
external microphone
speaker
speaker/microphone
jack
ground circuits with this radio. Damage
can result. We recommend using only
Cobra ® authorized accessories.)
6