ERASING ANY PRIOR PROGRAMS
This process enables you to easily clear the controller memory of all
user-defined watering program information within an individual
program. This is an optional procedure and can be skipped if you wish
to retain previous program operating information or the controller has
not yet been programmed.
Erasing a program resets the memory to factory conditions: No station
run time, program start time or active watering days. Water Budget is
set to 100% and Master Valve/Pump Start is set to be "On."
Note: This process is program independent and resets only the
information for the selected program.
To erase program information for a selected program:
1. Select Program
,
A
2. Turn the function dial to the
will show "
."
ERASE
3. Press and hold the
4. Repeat this procedure for each program you wish to erase.
SETTING THE STATION RUN TIME
A station is assigned to a program when it is given a station run time
(from 1 minute to 10 hours) in that program. The station can have only
one run time per program. Additionally, the station can be assigned to
any number of programs and have a different run time assigned in each.
To set the run time for each station:
1. Turn the function dial to the
controller displays
station run time).
2. Select Program
,
A
3. Press the
NEXT
set (if other than the one displayed).
4. Use the + and/or – buttons to display the desired station run time.
Note:
is the factory setting for each station. If the station has a
OFF
run time and you wish to remove it from this program, use the +
and/or – buttons to select
and
[one minute]). (
00:01
Programming the Controller
,
or
with the
Program
B
C
D
Program Erase
button until "
OFF
DONE
Station Times
1 and
STATION NUMBER
,
or
with the
Program
B
C
D
button to select the station number you wish to
, (displayed between
OFF
)
CONTINUED
switch.
position. The display
" is displayed.
position. The
(or the current
OFF
switch.
[ten hours]
10:00
11