Descargar Imprimir esta página

Sears 247.203693 Manual De Operación página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING
If the engine has been running, the muffler will be very hot. Be careful not
to touch the muffler.
Spark Plug Boot
2.
Visually inspect the spark plug. Discard the spark plug if there is apparent
wear, or if the insulator is cracked or chipped. Clean the spark plug with a
wire brush if it is to be reused.
3.
Measure the plug gap with a feeler gauge. Correct as necessary by
bending side electrode. See Figure 31. The gap should be set to between
0.024-0.031 in.
Electrode
0.024-0.031 in.
4.
Check that the spark plug washer is in good condition and thread the spark
plug in by hand to prevent cross-threading.
5.
After the spark plug is seated, tighten with a spark plug wrench to compress
the washer.
NOTE: When installing a new spark plug, tighten 1/2 turn after the spark
plug seats to compress the washer. When reinstalling a used spark plug,
tighten 1/8-1/4 turn after the spark plug seats to compress the washer.
IMPORTANT: The spark plug must be securely tightened. An improperly
tightened spark plug can become very hot and may damage the engine.
SERVICE AND MAINTENANCE
Spark Plug
Figure 30
Figure 31
Fuel Filter Service
Gasoline and its vapors are extremely flammable and explosive. Fire or
explosion can cause severe burns or death.
Keep gasoline away from sparks, open flames, pilot lights, heat, and other
ignition sources.
Check fuel lines, tank, cap, and fittings frequently for cracks or leaks. Replace
if necessary.
Before replacing the fuel filter, drain the fuel tank as in To Drain the Fuel.
Do not drain fuel when the engine is hot. Allow the engine adequate time to
cool. Drain fuel into an approved container outdoors, away from open flame.
Drain any large volume of fuel from the tank by disconnecting the fuel line
from the in-line fuel filter near the engine.
Remove the fuel line from the ln-line side (side towards the fuel tank) of the
fuel filter.
Replacement parts must be the same and installed in the same position as
the original parts.
If fuel spills, wait until it evaporates before starting engine.
Before replacing the fuel filter, drain the fuel tank. Otherwise, fuel can leak
out and cause a fire or explosion.
To Drain The Fuel:
1.
Locate the fuel filter, which is routed on the left side of the engine between
the fuel tank and the carburetor, and may be attached to the engine with a tie
strap. Cut the tie strap, if present, then pinch the in-line clamp on the fuel filter
with a pair of pliers, slide the clamp up the fuel line. Pull the fuel line free from
the filter and place the open end of the line into an approved container to drain
the fuel.
To Change The Fuel Filter:
1.
Use pliers to squeeze the tabs on the other clamp (the out-line side of the
fuel filter), and slide the clamp away from the fuel filter. Twist and pull the
fuel line off of the fuel filter. See Figure 32.
2.
Check the fuel lines for cracks or leaks. Replace if necessary.
3.
Replace the fuel filter with an original equipment replacement filter. Call
1-888-331-4569 to purchase the original equipment replacement
filter.
4.
Secure the fuel lines with the clamps.
The fuel filter cannot be cleaned and should be replaced every 100 operating hours;
more often if run with old gasoline.
25
WARNING

Publicidad

loading