3. S
ETUP
AC Power
Charging the
Battery
Battery Life
Indicator
Battery
Maintenance
Run-Time Table
Freedom™ Par RGBA and Strip Mini RGBA User Manual Rev. 4
All manuals and user guides at all-guides.com
The Freedom™ RGBA series has an auto-ranging power supply and it can work with an
input voltage range of 100~240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's bottom panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0–100% switch.
The Freedom™ RGBA series comes with a non-user-serviceable lithium-ion battery for
cable-free operation.
To charge the Freedom™ RGBA series battery, plug in the power cord at any time
before, during, or after operation. To charge the battery before or after operation with all
the LEDs off, leave the power switch in the Off position.
The battery life indicator located on the product displays the remaining amount of
internal battery life. Use the chart below to find out how much battery life remains per
charge cycle. The light to the far right flashes during charging.
The Freedom™ RGBA series battery should be charged 24 hours prior to initial
use for optimal battery life.
To keep the battery in optimal operating condition, store the product in a cool, dry place
and charge at least once every 30 days when not in use.
Avoid exposure to extreme temperatures. If the product is exposed to extreme cold or
hot temperatures, warm up/cool down the product before use and before charging.
Maximum Run Time
Up to 8 hours
Recharge Time
6 hours
Page 13 of 88