Troubleshooting; Maintenance; Service - Delta 17-959L Manual De Instrucciones

DRILLING METAL
Use clamps to hold metal workpieces. Never hold the workpiece in your bare hand. The drill bit can seize the work at
any time, especially when breaking through the workpiece and cause damage to the machine or injury to you. The drill
bit will break if the workpiece strikes the column.
Clamp the workpiece firmly. Any tilting, twisting, or shifting results not only in a rough hole, but also in bit breakage.
For flat work, lay the workpiece on a wooden base and clamp it firmly against the table to prevent it from turning. If
the workpiece is of irregular shape and cannot lay flat on the table, securely block or clamp it.
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.
FAILURE TO START
Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION & RUST PROTECTION
Apply household floor paste wax to the machine table, extension table or other work surface weekly. Or use a
commercially available protective product designed for this purpose. Follow the manufacturer's instructions for use
and safety.
To clean cast iron tables of rust, you will need the following materials: a sheet of medium Scotch-Brite™ Blending Hand
®
Pad, a can of WD-40 and a can of degreaser. Apply the WD-40
pad. Degrease the table, then apply the protective product as described above.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at servicenet.deltamachinery.com.
You can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278
to receive personalized support from highly-trained technicians.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about DELTA Machinery, its
factory-owned branches, or an Authorized Warranty Service Center, visit our website at www.deltamachinery.com or call
our Customer Care Center at 1-800-223-7278. All repairs made by our service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at DELTA Machinery, 4825 Highway 45 North, Jackson, Tennessee 38305 - Attention:
Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number, type, serial
number, etc.)

TROUBLESHOOTING

MAINTENANCE

SERVICE

19
®
and polish the table surface with the Scotch-Brite