Sanyo Classic PACi Serie Instrucciones De Instalación página 90

13-4. Wall-Mounted Type (K Type)
■ Name of Parts
K Type (Wall-Mounted)
■ Care and Cleaning
WARNING
● For safety, be sure to turn the air conditioner off and
also to disconnect the power before cleaning.
● Do not pour water on the indoor unit to clean it. This will
damage the internal components and cause an electric
shock hazard.
Air intake and outlet side (Indoor unit)
Clean the air intake and outlet side of the indoor unit with a
vacuum cleaner brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with
water. When cleaning the air outlet side, be careful not to force
the vanes out of place.
CAUTION
● Never use solvents or harsh chemicals when cleaning
the indoor unit. Do not wipe plastic parts using very hot
water.
● Some metal edges and the fins are sharp and may cause
injury if handled improperly; be especially careful when
you clean these parts.
● The internal coil and other components must be cleaned
regularly. Consult your dealer or service center.
Air filter
The air filter collects dust and other particles from the air and
should be cleaned at regular intervals as indicated in the table
below or when the filter indication ( ) on the display of the
remote control unit (wired type) shows that the filter needs
cleaning. If the filter gets blocked, the efficiency of the air
conditioner drops greatly.
Type Period
K 2 weeks
N OT E
The frequency with which the filter should be cleaned depends
on the environment in which the unit is used.
<How to clean the filter>
1. Remove the air filter from the air intake grille.
2. Use a vacuum cleaner to remove light dust. If there is sticky
dust on the filter, wash the filter in lukewarm, soapy water,
rinse it in clean water, and dry it.
<How to remove the filter>
1. Move the flap on the air outlet grille to its lowest position
with the remote control unit.
2. The filter is disengaged by pushing the tab up gently. Hold
the air filter by the tab at the bottom, and pull downward.
Air intake
Air outlet
When replacing the filter, make sure that the FRONT mark is
facing you.
Push it up until you hear it click back into position.
● Certain metal edges and the condenser fins are sharp
● Periodically check the outdoor unit to see if the air outlet
● The internal coil and other components must also be
Care: After a prolonged idle period
Check the indoor and outdoor unit air intakes and outlets for
blockage; if there is a blockage, remove it.
Care: Before a prolonged idle period
● Operate the fan for half a day to dry out the inside.
● Disconnect the power supply and also turn off the circuit
● Clean the air filter and replace it in its original position.
● Outdoor unit internal components must be checked and
88
Air intake grille
Air filter
CAUTION
and may cause injury if handled improperly; special care
should be taken when you clean these parts.
or air intake is clogged with dirt or soot.
cleaned periodically. Consult your dealer or service
center.
breaker.
cleaned periodically. Contact your local dealer for this
service.