Assembly - Skil 3302 Instrucciones De Funcionamiento Y Seguridad

SM 2610028634 12-12_SM 2610028634 12-12.qxp 12/20/13 10:50 AM Page 6
TOOLS NEEDED FOR ASSEMBLY
• Adjustable wrench
®
• Phillips screwdriver
PREPARING THE STAND
See Figure 1.
1. Lay the stand's top surface down on the floor with
the folded legs on top.
2. Push in a leg locking pin (1) and rotate that leg up
until the locking pin clicks into place.
3. Repeat with the remaining three legs.
4. Lift the stand and place it in an upright position.
5. Check to ensure the stand is stable and all the legs
have the locking pins engaged.
ASSEMBLING AND INSTALLING
MATERIAL wORK SUPPORTS
See Figures 2 - 3.
The material work supports help balance the
workpiece during cutting operations.
To assemble the work support:
1. Slide a M6 x 60 mm carriage bolt (2) through the
square hole in the work support (3) and extend
through the other side.
2. Place the work stop (4) over the end of the bolt.
3. Thread a work stop adjustment knob (5) over the
end of the bolt and tighten to secure.
To install the work supports:
1.Slide the work support (3) into the extension rail (6).
Position the work support at the desired height on
the extension rail and tighten (7) in place.
2.Repeat with the other support.

Assembly

FIG. 1
FIG. 2
5
FIG. 3
6
1
2
4
3
3
7
6