Attaching Saw With Quick Mount™ System To Stand - Skil 3302 Instrucciones De Funcionamiento Y Seguridad

SM 2610028634 12-12_SM 2610028634 12-12.qxp 12/20/13 10:50 AM Page 7
Attaching saw with Quick Mount System™ to stand
W RNING
to the stand. Unintended startup during assembly can
cause injury.
Make sure stand is fully assembled.
Place stand on solid, level surface.
See Figures 4 - 5.
1. Rotate the two quick clamp knobs 1 on each side of
the rear portion saw base counterclockwise until
they are retracted as far as they willl go.
2. Lift the saw, allowing it to tilt slightly away from your
body.
3. While still tilted away from you, hook the rear edge
of the saw base onto the rear rail 2 of the stand,
figure 4.
W RNING
the saw base and clamps are securely seated over
the rear rail before seating the other end of the
saw base. Failure to do so could cause you to lose
control of the saw mounting assembly.
4. Lower the saw to allow the front edge of the saw
base to seat fully over the front rail, figure 5.
5. Check position and adjust, if necessary, to make
sure the weight of the saw is evenly balanced over
the rails as shown in figure 5.
6. Rotate the two quick lock knobs 1 clockwise and
securely tighten.
7. Ensure the saw base is fully seated and locked in
position.
To remove saw from stand:
1. Rotate the two quick clamp knobs counter
clockwise.
2. Lift the saw away from the front rail of the stand to
disengage.
3. With the assembly tilted slightly away from you, lift
the rear part of the saw base to disengage from the
front rail of the stand.
(Saw not included)
Turn tool switch off
disconnect power before mounting
To avoid serious personal injury,
make sure the curved rear edge of
and
1
2
FIG. 5
1
7
FIG. 4